![]() ![]() ![]() BLACK goes to GROUND, and RED, to the positive post on the battery Various other sites seem to say what I'd always thought, which is to use the two battery terminals, but some people here seem convinced that this risks an explosion, even if you don't turn on any power until both croc clips are connected: Hence why, you remove the battery from the vehicle. The ground connection for a battery charger, used at a 2-4 amp rate (trickle charging) should ALWAYS be applied direct to the ground side post of the battery. Secondly, you do NOT hook a battery charger up to charge a battery by applying an alternate ground source, i.e. I can tell you right now, that you, and the author of the original post don't know what you're talking about. I am a professional, factory Toyota trained technician. which is confusing, not only because it seems to contradict itself (first it advocates never using the negative battery terminal, then at the end it says to use it after all), but also because there's a mess of disagreements in the comments, for example. ![]() Once everything is in place, connect the trickle charger to a power socket. Do not touch the wires while the charger is plugged in and turned on, as serious shock or injury may occur.Ĭonnect the black clip to the negative batter terminal and the red clip to the positive one. It is important to ensure that this negative wire is solidly attached before plugging in your charger. Once you have ensured you have a solid connection, connect the black, negative wire to your ground location located in step 2. Take the red or positive cable and attach it to the positive terminal of the battery to be charged. There should be a black clip and a red clip. Attach CablesĬonnect the alligator clips. The negative terminal on the battery should never be used, as it can cause an explosion or fire. Ideally a spot of bare metal on the frame, or a large bolt attached to the chassis or engine block should be used, but if one cannot be located, a section of the frame that is free of excessive dirt, grime and oil will suffice. Locate a Suitable Ground Locationįinding a suitable location to attach the negative terminal of your charger is the key to safe and effective completion of your trickle charger circuit. I thought this couldn't be simpler: ventilate, unhook the battery, connect the positive first, then the negative, then turn on the power. Try it! I think it will work for you and may save hundreds in replacements all for a reasonable price.I'm trickle-charging a car using direct connections to the battery. My battery was in such a low state it showed no voltage but was quickly brought back to full efficiency in about a week. It uses advanced technology to ascertain a battery functionality and determine its future use - quite handy. This device is more than a simple battery charger. It put my battery through a repair process before going into a trickle-charge maintenance state. This system by Gooloo works well and more. I worried the toll that may have on the overall life of my battery and decided I needed something that trickle-charged to top-up and maintain. I first purchased a NOKU-type rechargeable booster which started the car but left me unable to drive sufficiently to recharge the battery and it soon required a boost start again. Something was draining the battery (probably advanced keyless entry). I found my stored 2011 MX5 had a drained battery several times during the storage period and the battery had been replaced recently. Apr 09 There Money Market Investments.Apr 09 Off Buying Stocks Designer Wom.Dec 05 Back Online After Database Fai.Jul 01 Colorado Million Dollar Highwa.Sep 03 NYAutumn Sports Classic Super C.Aug 27 NYMGCC Sports Car & Auto Festival. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |